Study of plasma sprayed ceramic coatings for high power density microwave loads

In the framework of thermonuclear fusion research, increasing interest is focussed on high power, high frequency millimeter-wave generators like gyrotrons. Measurements of gyrotron power and energy allow an accurate energy balance in ECRH (Electron Cyclotron Resonance Heating) to be carried out during plasma heating. The expected increase of the power, up to 2 MW, and time, up to 10 s (or continuous wave), calls for new technological solutions in manufacturing bolometric loads, particularly in making use of absorbing layer ceramics very resistant to thermal shocks. In this particular case, also a good absorption capability at 140 GHz is requested. revious work [N. Spinicchia, et al., Proc. of 16th Congress Italian Association of Vacuum, Catania (I), ed. Compositori, Bologna, Italy, 2002, p. 259], we studied alumina based coatings with various techniques—ESEM (Environmental Scanning Electron Microscopy), micro-analysis with X-ray EDS, Differential Scanning Calorimeter (DSC), X-ray diffraction analysis (XRD). It has been shown that repeated exposures to high energy fluxes causes the degradation of the coating. esent work is devoted to studying and selecting an absorbing ceramic coating to be deposited on the inner surface of the load. The aim is to characterize the material with respect to absorbing capability at a frequency of 140 GHz and thermal shock and fatigue resistance caused by long-term exposure to high power millimeter-wave radiation. Bolometric loads are planned to resist to 1–2 MW power continuously. s purpose APS (Air Plasma Spray) and VPS (Vacuum Plasma Spray) ceramic coatings have been studied to search for a convenient substitute to the actual Alumina–Titania coating (Al2O3–13TiO2). A number of physical parameters such as thermal conductivity, thermal expansion coefficient, coating porosity and melting point were also considered to select among the candidate coatings.