Combination of coating and heat treatment processes

For a proper use of coated tools and components excellent coating properties as well as excellent substrate properties of the coating/substrate composite are necessary. A well known example is the load support of hard steel substrates for thin wear resistant coatings. Therefore coating processes must be combined with heat treatment processes of the substrates, whereby several practical processing constraints like order and compatibility of the applied treatment procedures must be considered. The combination of CVD-coating plus laser beam hardening is an example of a post coating heat treatment. Applications may be possible for large forming tools made of high alloyed tool steels, which nowadays are usually through hardened after CVD-coating. Laser beam hardening offers the possibility, to harden only the highly loaded edges of the tools. The advantages of this combination are short process time, less distortion and compressive residual stresses in the substrate surface. CVD-coatings can endure laser beam hardening with suitable parameters. The influence of CVD TiN-coated steel substrates and laser beam hardening parameters on microstructures and properties of coating/substrate compounds have been investigated. Special attention was paid to overlapping hardening zones, which may occur at the start and end points of a laser hardened track. In summary, the combination of coating and heat treatment processes show a high potential to produce coating/substrate compounds with excellent coating properties as well as excellent substrate properties.