Oxidation control in atmospheric plasma spraying coating

Thermal spray coatings are formed by successive impingements and interbonding materials among the splats, solidified individual molten particles. Depending on the processing conditions employed during the spray process, deposits are produced with an assortment of microstructures and properties. This study highlights how the coating oxidation differences are influenced by the mechanisms involved during the spray process. The commercial steel powder referenced Amdry XPT 512 is chosen for a systematic study of comparison across different spraying techniques. Steel particles were sprayed with a F4 plasma torch and with a shrouded plasma spray process used in order to protect particles against atmospheric oxidation. The plasma jet was successively shielding by an inert gas shroud and by an oxidizing gas shroud. In-flight oxidation and post impact oxidation present in coatings are discussed in detail and the effects of these mechanisms on coating properties are addressed. The comparison was made on in-flight particle characteristics and on coating properties in terms of oxide content and porosity level. Using shrouded gas, in-flight characteristics are quite similarly independent of the nature of the shrouded gas. This way, the comparison of oxide contents present in the coatings corresponds to in-flight oxidation and is completely dependent on the nature of the shrouded gas. Comparing these results to those obtained by APS, a decrease in both velocity and temperature of in-flight particles was observed leading also to a significant decrease in oxide contents and to a slight increase in porosity level compared to coatings sprayed with air shrouding.