Influence of time on the microstructure of AISI 321 austenitic stainless steel in salt bath nitriding

Influence of nitriding time on the microstructure and microhardness of AISI 321 austenite stainless steel was investigated, using a complex salt bath heat-treatment at low temperature, 430 °C. Experimental results revealed that after salt bath nitriding, a modified layer was formed on the surface of substrate with the thickness ranging from 2 μm to 30 μm with changing treating time. The nitrided layer depth thickened extensively with increasing nitriding time. The growth of the nitrided layer takes place mainly by nitrogen diffusion according to the expected parabolic rate law. Scanning electron microscopy and X-ray diffraction showed that in 321 stainless steel subjected to complex salt bathing nitrided at such temperature for less than 8 hours, the main phase of the nitrided layer was expanded austenite (S phase) by large. When the treatment time is prolonged up to 8 hours and more, S phase is formed and subsequently transforms partially into CrN, and then the secondary CrN phase precipitated. With treating time prolonged, more CrN precipitates formed along the grain boundaries in the outer part. In the inside part between the some CrN and the substrate, there is still a broad single S phase layer. All treatments can effectively improve the surface hardness.