The size of solid lipid nanoparticles: An interpretation from experimental design

This study aimed to investigate the role of different factors affecting the size of solid lipid nanoparticles (SLN), prepared by the emulsification–solvent evaporation method. A double factorial design was conducted so as to cover a wide range of sizes, highlighting zones with different behaviour with respect to changes in the controlled variables: lipid concentration, solvent:lipid ratio and emulsifier concentration. lvent:lipid ratio constituted the main factor influencing particle size. Increasing the amount of solvent induced a decrease in the size. This was a general trend, essentially independent from solvent and lipid type. The amount of emulsifier had a non-trivial impact on size, depending on whether systems were located below, above or close to the optimal surface coverage. The amount of lipid had a limited influence upon particle size, being more relevant for lower lipid concentrations. An optimal formulation was selected for intermediate levels of the three variables. Sonication reduced both particle size and polydispersity. These particles were also tested as drug carriers using simvastatin as a model of lipophilic drug. SLN were able to entrap a high amount of simvastatin, with little effect upon size and zeta potential, constituting a promising carrier for lipophilic drugs.