Regulation of cellular responses to macroporous inorganic films prepared by the inverse-opal method

Regenerative medicine for repairing damaged body tissues has recently become critically important. Cell culture scaffolds are required for the control of cell attachment, proliferation, and differentiation in in vitro cell cultures. A new strategy to control cell adhesion, morphology, and proliferation was developed by culturing mouse osteoblast-like MC3T3-E1 cells on novel cell culture scaffolds fabricated using ordered nanometer-sized pores (100, 300, 500, and 1000 nm). s of this study indicate that after 72 h of incubation, the number of cells cultured on a silica film with a pore size of 1000 nm was similar to or slightly lower than that cultured on a non-porous control silica film. Films with 100–500 nm pore sizes, however, resulted in the cell growth inhibition. Morphology of the cultured cells revealed increased elongation and the formation of actin stress fibers was virtually absent on macroporous silica films with 100–500 nm pore size. Vinculin molecules expressed in cells cultured on the non-porous silica films showed many clear focal adhesions, whereas focal contacts were insufficiently formed in cells cultured on macroporous films. The influence of hydroxyapatite (HAp) and alumina scaffolds on the behavior of MC3T3-E1 cells was also evaluated. The proliferation rate of MC3T3-E1 cells cultured on HAp films with 1000 nm pore size was increased to approximately 20% above than that obtained of cells cultured on non-porous HAp films. These results demonstrate that the pore size and constituents of films play a role in controlling the morphology and proliferation rate of MC3T3-E1cells.