Author/Authors :
Wang، نويسنده , , Jun and Ma، نويسنده , , Teng and Zhang، نويسنده , , Zhaohong and Zhang، نويسنده , , Xiangdong and Jiang، نويسنده , , Yuefeng and Sun، نويسنده , , Wei and Li، نويسنده , , Ronghe and Zhang، نويسنده , , Peng، نويسنده ,
Abstract :
The transition crystal TiO2 catalyst with high sonocatalytic activity was obtained utilizing the microwave irradiation in hydrogen peroxide solution. At the same time a series of affecting factors (microwave irradiation time, heat-treated time and heat-treated temperature) to prepare the TiO2 catalyst on the sonocatalytic degradation of parathion were considered in this paper. The ultrasound of low power was used as an irradiation source to induce treated TiO2 particles to perform catalytic activity. The results show that the sonocatalytic activity of the transition crystal TiO2 powder is obviously higher than those of pure ordinary rutile and anatase TiO2 powders. At last, the parathion in aqueous solution was degraded completely and became some simple inorganic ions such as NO 3 - , PO 4 3 - , SO 4 2 - , etc. The degradation ratio of parathion in the presence of the transition crystal TiO2 catalyst attains nearly 80% within 60 min ultrasonic irradiation, while corresponding ones are only 65.23% and 53.88%, respectively, for pure ordinary rutile and anatase TiO2 powders.
Keywords :
Transition crystal TiO2 catalyst , microwave irradiation , Sonocatalytic degradation , Parathion