Microstructure and texture of a lightly deformed TRIP-assisted steel characterized by means of the EBSD technique

The microstructural and textural changes after a tensile strain of 10% were observed by orientation contrast measurements in a TRIP-assisted steel. On the undeformed samples it was shown that the electron back scatter diffraction (EBSD) technique could be used successfully for determining the volume fraction of the microstructural constituents bainite, ferrite and austenite, whereas after deformation only the BCC and FCC phases could be separated. The results show that the tensile strain of 10% gave rise to a drop in residual austenite content from 10 to 4%, which was also confirmed by magnetic measurements. xture data showed only minor orientation rotations after 10% tensile strain for the BCC ferrite and bainite grains, whereas the residual austenite did show a significant texture change. By meticulously monitoring the local intra-granular misorientations it was concluded that the BCC phases (ferrite and bainite) took up the larger part of the nominal strain whereas the residual austenite primarily responded to the mechanical load by a partial (stress-induced) martensite transformation. Hence, the texture change observed in the residual austenite could be attributed to the orientation selective character of the phase transformation.