Effect of cooling rate on the microstructure evolution and mechanical properties of homogenized Mg–Gd–Y–Zn–Zr alloy

Different cooling processes, such as quenching in warm water and cooling in furnace, were introduced to homogenize Mg–8.2Gd–3.8Y–1.0Zn–0.4Zr (wt%) alloy. Microstructure evolution and mechanical properties of the homogenized alloy were investigated. The as-quenched sample was comprised of α-Mg matrix, Mg5RE phase and 18R LPSO phase distributed at the grain boundaries and a few of RE-rich particles distributed randomly. During the process of cooling in furnace, Mg5RE and 18R LPSO phases were transformed into block-shaped 14H LPSO phase and lamellar-shaped 14H LPSO phase, respectively, due to the diffusion of solute atoms into the α-Mg matrix. Furthermore, the lamellar-shaped 14H LPSO phase grew and ran through the whole grains. The as-quenched sample exhibits tensile yield strength of 130 MPa, ultimate tensile strength of 206 MPa and elongation to failure of 5.5%, while the sample cooled in the furnace exhibits higher tensile yield strength but lower ultimate tensile strength and ductility due to the coarse grains and formation of block-shaped 14H LPSO phase.