Title of article
Plastic scintillator produced by the injection-molding technique
Author/Authors
Yoshimura، نويسنده , , Y and Inagaki، نويسنده , , T and Morimoto، نويسنده , , T and Sugai، نويسنده , , I and Kuriki، نويسنده , , M and Shirai، نويسنده , , R and Goto، نويسنده , , M and Yamashina، نويسنده , , T، نويسنده ,
Issue Information
روزنامه با شماره پیاپی سال 1998
Pages
7
From page
435
To page
441
Abstract
Plastic scintillators based on polystrene and a polystyrene derivative (MS resin) have been produced by the injection-molding technique, and the light yield, transmission, fluorescence, sunshine hardness and radiation hardness were compared with those of casting scintillators. It was also investigated whether or not a fluorescent lamp affected the transparency.
Keywords
Plastic scintillator , Injection molding , Light yield , Vacuum hardness , fluorescence , Radiation hardness
Journal title
Nuclear Instruments and Methods in Physics Research Section A
Serial Year
1998
Journal title
Nuclear Instruments and Methods in Physics Research Section A
Record number
2177628
Link To Document