Analysis of counter-current gas–water capillary imbibition transfer at different temperatures

Gas water counter-current matrix–fracture interaction due to capillary forces was studied. The focus was on the rate of capillary imbibition and the development of residual gas phase under low (20 °C) and high temperatures (90 °C). Berea sandstone and Indiana limestone samples with different shape factors were obtained by cutting the plugs 1, 2.5, and 5 cm in diameter and 2.5, 5, and 10 cm in length. All sides were coated with epoxy except one end. Static imbibition experiments were conducted on vertically and horizontally situated samples where the matrix–fracture interaction took place upward and lateral directions, respectively. The effects of the matrix shape factor, wettability, surface tension, and core position on the recovery rate and ultimate recovery were investigated. perimental scheme followed was useful in identification of the development of residual gas saturation for fully counter-current matrix–fracture interaction. We investigated and clarified to what degrees the rock/fluid properties (wettability and matrix shape factor) and existing conditions (temperature, causing lowered IFT and brine viscosity, and gravity) become effective on the residual gas saturation. It was observed that the residual gas saturation is sensitive to the matrix shape factor. The effect of surface tension on the recovery rate and ultimate recovery was also critical. The vertical cases yielded different recovery rates and ultimate recoveries with increasing temperature. Lower residual gas saturation with increasing temperature was obtained only for large diameters. That was attributed to the reduction in surface tension. y, critical matrix and fluid properties were correlated to the residual gas saturation and different dimensionless groups were tested for scaling.