The Malpica–Lamego Line: a major crustal-scale shear zone in the Variscan belt of Iberia

The Malpica–Lamego Line (MLL) is a deformation zone in the Variscan belt of NW Iberia (NW Spain and N Portugal) that runs parallel to the chain for at least 275 km, bearing I-type granodiorite plutons along most of its length. The MLL affects previous structures by which high pressure and ophiolitic rocks were exhumed and emplaced on the Iberian plate during earlier deformation phases. Correlation and reconstruction of the stratigraphy of these sheets or tectonic units at both sides of the shear zone allows a preliminary estimate of the accumulated vertical and horizontal offsets after the tectonic activity of the fault. The value of the separations, of crustal-scale proportions, reaches a maximum 15 km of vertical offset that decreases gradually to the south. The structural record found in the rocks indicates a strike-slip regime that, in general, does not fit the geometry of the offsets. We suggest that the MLL went through two different stages during the same orogenic cycle: a first dip-slip episode, a reverse faulting event, overprinted by a later strike-slip reactivation.