Very high strains recorded in mylonites along the Alpine Fault, New Zealand: implications for the deep structure of plate boundary faults

Oblique displacement on the Alpine Fault, which forms the principal structure along the Australian–Pacific plate boundary in South Island, New Zealand, has resulted in exhumation of a kilometre-wide mylonite zone in the hanging wall adjacent to the current brittle fault trace. The mylonites formed under amphibolite facies conditions at depths of ca. 25 km and have been uplifted during the past 5 Ma. A suite of 65–70 Ma pegmatite veins in the hanging wall Alpine schists has been progressively deformed within the mylonite zone and sheared out over a strike length of ca. 100 km. Measurements of the thickness distribution of the pegmatite veins within the non-mylonitised schists and at three localities within the progressively strained mylonites have been used to estimate strain values within the mylonites. The thicknesses approximate a log-normal distribution, with a mean value that is progressively reduced through the protomylonites, mylonites and ultramylonites. By assuming that the thickness distribution currently observed in the schists was the same for the pegmatites within the mylonites before strain, a model of deformation incorporating simple shear and simultaneous pure shear is used to strain the undeformed veins until a fit is obtained with the strained distributions. Shear strains calculated range from 12 to 22 for the protomylonites, 120 to 200 for the mylonites and 180 to 300 for the ultramylonites, corresponding to pure shear values of 1–3 in each case. These values are compatible with the strains predicted if most of the surface displacement on the fault over the past 5 Ma were accommodated within a 1–2-km-wide mylonite zone through the middle and lower crusts. The results suggest that processes such as erosional focussing of deformation and thermal weakening may cause intense strain localisation within the lower crust, with plate boundary deformation restricted to narrow zones rather than becoming increasingly distributed over a widening shear zone with depth.