Characterization of an acoustic liner by means of Laser Doppler Velocimetry in a subsonic flow

This paper describes a new experimental approach to acoustic liner characterization in the presence of a grazing flow. The traditional methods of measurement use microphones to determine liner impedance. The in situ method in particular requires the simultaneous use of two microphones. The first is mounted flush with the surface of the liner grazed by the flow and the second is flush-mounted to the rear face of the liner. However, this method is invasive and assumes the reaction of the liner to be independent of the incidence of the waves (locally-reacting liner). The approach suggested here is radically different since Laser Doppler Velocimetry (LDV) is used to measure the acoustic perturbation of velocity, or acoustic velocity. This latter allows us to determine the acoustic displacement, which is the key parameter in Galbrunʹs linear theory for assessing the perturbation of pressure and the field of active intensity. The wall impedance and the propagation paths of acoustic energy in the presence of the liner may be deduced without any assumption and non-invasively. This approach was applied for characterizing a resistive liner in a test bench specially designed for aeroacoustic measurements, with a 2D LDV system. The flow was turbulent and the measured nominal Mach number was 0.13. The impedance and field of active intensity were then obtained. A comparison was carried out between the new approach and the in situ method using microphones. According to previous theoretical works in the literature and the presented test results, one has to be cautious about the definition of the impedance when performing in-flow acoustic measurements.