Effects of reduced inflation pressure and vehicle loading on off-road traction and soil stress and deformation state

Field experiments on off-road vehicle traction and wheel–soil interactions were carried out on sandy and loess soil surfaces. A 14 T, 6 × 6 military truck was used as a test vehicle, equipped with 14.00-20 10 PR tyres, nominally inflated to 390 kPa. Tests were performed at nominal and reduced (down to 200 kPa) inflation pressures and at three vehicle loading levels: empty weight, loaded with 3.6 and 6.0 T mass (8000, 11,600 and 14,000 kg, respectively). Traction was measured with a load cell, attached to the rear of the test vehicle as well as to another, braking vehicle. Soil stress state was determined with the use of an SST (stress state transducer), which consists of six pressure sensors. Soil surface deformation was measured in vertical and horizontal directions, with a videogrammetric system. Effects of reduced inflation pressure as well as wheel loading on traction and wheel–soil interactions were analyzed. It was noticed that reduced inflation pressure had positive effects on traction and increased stress under wheels. Increasing wheel load resulted in increasing drawbar pull. These effects and trends are different for the two soil surfaces investigated. The soil surface deformed in two directions: vertical and longitudinal. Vertical deformations were affected by loading, while longitudinal were affected by inflation pressure.