Measurement of compacted soil density in a compaction of thick finishing layer

The compaction of a soil is one of the important construction operations that influences the durability of soil structure. Therefore, the measurement of soil density, used to judge the degree of compaction, has to be performed exactly. Since a compaction of a thick finishing layer could be executed with the enlargement of compaction machinery and the improvement of productivity, new equipment which can measure the soil density in a deep stratum has to be developed. In this paper, we propose a method of accurately estimating compacted soil density based on the three dimensional stresses measured in the ground during compaction by a stress state transducer (SST). A tracked vehicle mounted with a vertical oscillator was used to compact a decomposed granite soil of 45 cm depth. A model experiment was executed at a frequency that was varied from 16 to 25 Hz, setting the load ratio of maximum oscillating force to the vehicle weight (4.9 kN) to be 1.2, 1.6 and 2.0. The three dimensional stresses in the ground were measured by use of the SST. Comparing the dry density converted from cone penetrometer test results and the dry density estimated from Baily’s formula, the compacted soil density at the lowest soil stratum could be estimated by measuring earth pressure using SST.