Titanium oxide films produced on commercially pure titanium by anodic oxidation with different voltages

Titanium oxide films produced on commercially pure Ti by anodic oxidation with different voltages were analyzed. Anodic oxidation was carried out at room temperature using 1.4 M H3PO4 electrolyte and a platinum counter-electrode, in potentiostatic mode under the following conditions: 50 V, 100 V, 150 V, 200 V and 250 V. It was observed that porous titanium layers were formed at all voltage values but morphological differences were observed. Initially, the film was thin but with increasing voltage it broke down locally and porous regions became evident due to the dielectric breakdown. The porosity and the pore size increased with the increasing voltage. The surface morphology in samples formed with 200 V had substantially different porous structures than those formed with other voltage values. The anodic film surface displayed pores and craters formed on the relatively flat ground oxide surface. AFM images showed that higher voltages produced thicker titanium oxide films.