Effect of thermal cycling on flexural properties of carbon–graphite fiber-reinforced polymers

Objectives ermine flexural strength and modulus after water storage and thermal cycling of carbon–graphite fiber-reinforced (CGFR) polymers based on poly(methyl methacrylate) and a copolymer matrix, and to examine adhesion between fiber and matrix by scanning electron microscopy (SEM). s t cleaned carbon–graphite (CG) braided tubes of fibers were treated with a sizing resin. The resin mixture of the matrix was reinforced with 24, 36, 47 and 58 wt% (20, 29, 38 and 47 vol.%) CG-fibers. After heat polymerization the specimens were kept for 90 days in water and thereafter hydrothermally cycled (12,000 cycles, 5/55 °C). Mechanical properties were evaluated by three-point bend testing. After thermal cycling, the adhesion between fibers and matrix was evaluated by SEM. s hermal cycling did not decrease flexural strength of the CGFR polymers with 24 and 36 wt% fiber loadings; flexural strength values after thermocycling were 244.8 (±32.33) MPa for 24 wt% and 441.3 (±68.96) MPa for 36 wt%. Flexural strength values after thermal cycling were not further increased after increasing the fiber load to 47 (459.2 (±45.32) MPa) and 58 wt% (310.4 (±52.79) MPa). vealed good adhesion between fibers and matrix for all fiber loadings examined. sions mbination of the fiber treatment and resin matrix described resulted in good adhesion between CG-fibers and matrix. The flexural values for fiber loadings up to 36 wt% appear promising for prosthodontic applications such as implant-retained prostheses.