Title of article :
Morphological/chemical imaging of demineralized dentin layer in its natural, wet state
Author/Authors :
Wang، نويسنده , , Yong and Yao، نويسنده , , Xiaomei، نويسنده ,
Issue Information :
روزنامه با شماره پیاپی سال 2010
Abstract :
Objective
ing the structure, composition or suitability for bonding of the acid-etched dentin substrate, especially in its hydrated state, has been a formidable problem. The purpose of this study was to determine the morphological and structural profiles of the dentin demineralized layer measured in its natural wet state using environmental scanning electron microscopy (ESEM) and micro-Raman imaging.
als and methods
clusal 1/3 of the crown was removed from nine extracted, unerupted human third molars. Dentin surfaces were abraded with 600-grit SiC sandpaper under water to create smear layers. The prepared dentin surfaces were randomly selected for treatment with the self-etching agent (Adper™ Prompt L-Pop) or the total-etching agent 35% H3PO4 gel (with/without agitation). Micro-Raman spectra and imaging were acquired at 1–1.5 μm spatial resolution at positions perpendicular to the treated surfaces; since this technique is non-destructive, the same specimens were also imaged with ESEM. Specimens were kept wet throughout spectral acquisition and ESEM observations.
s
ould be used to reveal demineralized layers in acid-etched dentin, but the resolution was low and no collagen fibrils were disclosed. The detailed chemical maps/profiles of demineralized dentin layers under wet conditions could be obtained using Raman imaging. It was shown that the mineral existed in the superficial layer of all etched dentin covered with smear layers. The mineral was much easier to be removed underneath the superficial layer. The depth, degree, and profile of dentin demineralization were dependent on the types of acids (self-etching vs. total etching) and application procedures (with vs. without agitation).
icance
urrent adhesives are applied using wet bonding techniques in which the dentin is kept fully hydrated throughout the bonding. Our ability to fully characterize the hydrated, etched dentin substrates is very important for understanding bonding under in vivo conditions.
Keywords :
Demineralization , Raman , Environmental SEM , Acid etching , Dentin
Journal title :
Dental Materials
Journal title :
Dental Materials