Effect of air-abrasion on the retention of zirconia ceramic crowns luted with different cements before and after artificial aging

Objectives rpose of this in vitro study was to evaluate the effect of intaglio surface air-abrasion on the retention of CAD/CAM produced zirconia ceramic crowns cemented with three different types of cement. In addition the influence of artificial aging in masticatory simulator and thermocycling was tested. s ted human premolars were prepared for all-ceramic crowns (12° taper, 3 mm axial length). CAD/CAM zirconia crowns were manufactured. Half of the crowns were air-abraded with 50 μm alumina particles at 0.25 MPa, the rest was left as machined. The crowns were luted with zinc phosphate cement (Hoffmann), glass ionomer cement (Ketac Cem), or composite resin (Panavia 21), subgroups were either stored for 3 days in 37° water bath or stored for 150 days in 37° water bath, with additional 37,500 thermal cycles (5–55°) and 300,000 cycles dynamic loading with 5 kg in a masticatory simulator. Then crown retention was measured in tension at a crosshead speed of 2 mm/min using a universal testing machine. Statistical analysis was performed with three-way ANOVA. s etention values were ranged from 2.8 to 7.1 MPa after 3 days and from 1.6 to 6.1 MPa after artificial aging. Air-abrasion significantly increased crown retention (p < 0.001), while artificial aging decreased retention (p = 0.017). In addition, the luting material had a significant influence on retention (p < 0.001) with the adhesive luting resin providing the highest retention. icance e of phosphate monomer containing composite resin on air-abraded zirconia ceramic can be recommended as most retentive luting method.