Cyclic fatigue testing of denture teeth for bulk fracture

AbstractObjectives al experience with implant-supported dentures indicates that fracture and chipping of teeth are becoming an issue. Tooth fracture and chipping rates of approximately 2.5% per year are being experienced at one university. There has been no standardized test developed for bulk fracture or chipping of denture teeth. Such a test would aid in the development of improved teeth and in their evaluation. s l incisor teeth were embedded in acrylic and loaded on incisal edges at 90° to their long axes. Teeth tested included ones commercially available and two sets made from improved materials designed to increase toughness. Cyclic loading was done at 5 Hz from 20 N to 135 N, 150 N, 175 N and 200 N. Data was analyzed using lifetime analysis software fit at each of the accelerated loads and then extrapolated to clinical use loads (Alta 7, Reliasoft Corp.) Clinical use loads were derived from extrapolation of probability of failure (Pf) data to 2.5% Pf. s arefully embedded, teeth could be reproducibly loaded to failure by bulk fracture involving a failure mode similar to that seen clinically. Clinical use loads were calculated to be in the range of 70 N. Results from accelerated loading could be fit to similar probability of failure distributions allowing extrapolation to clinical use loads. icance ork was able to develop a clinically valid bulk fracture test for the fatigue failure of incisor denture teeth. It appears that teeth fabricated with improved materials will be expected to perform better clinically. Thus both the null hypotheses were rejected.