Ductile crack growth and constraint in pipelines subject to combined loadings

An important failure mode of offshore pipelines is ductile fracture of the pipe wall triggered by a hypothetical welding defect. In this study, pipelines having an external part-through semi-circumferential crack of various sizes, subject to combined internal pressure and inelastic bending are considered. This is done to assess the response of pipelines during both their installation and operational conditions. Detailed 3D nonlinear finite element (FE) models of pipelines are developed. A row of elements ahead of the initial crack front are modeled using a voided plasticity material model, which enables simulation of crack growth and the subsequent fracture failure mode (denoted by the critical curvature, κcrit). After discussing the typical response characteristics of such pipelines, the FE model is used to parametrically investigate the influence of varying pipe and crack dimensions, and also the internal pressure levels, on κcrit. In the second part of this paper, the crack tip constraint ahead of a growing crack in such pipes is evaluated and systematically compared to the crack tip constraint of both the traditionally used deeply cracked Single Edge Notch Bend (SENB) specimens and the constraint-matched Single Edge Notch Tensile (SENT) specimens. This is achieved by comparing the crack resistance curves (R-curves) along with stress triaxiality and equivalent plastic strain fields evaluated ahead of a growing crack of the three systems. The results present grounds for justification of usage of SENT specimens in fracture assessment of such pipes as an alternative to the traditional overly conservative SENB specimens.