The influence of pre-compression on the creep deformation and failure behaviour of Type 316H stainless steel

The influence of pre-compression to 8% plastic strain at room temperature has been examined on the tensile properties, uniaxial creep deformation, creep crack initiation and growth behaviour of Type 316H stainless steel at 550 °C. Uniaxial creep and crack growth tests have been performed on the pre-compressed (PC) material and the results compared to existing long term (>15,000 h) and short term test data on as-received (AR) (i.e. uncompressed) material. Pre-compression has been found to increase the materials subsequent yield stress in tension. Therefore the extent of non-linearity observed on the load–displacement curves of uniaxial creep rupture and crack growth tests on PC material is limited compared to AR material. In addition pre-compression causes a significant reduction in creep ductility and rupture time, although similar average and minimum creep strain rates are found in PC and AR materials. The creep crack growth (CCG) data on PC and AR materials have been characterised using the steady state creep C* parameter employing appropriate validity criteria and geometry dependent fracture mechanics parameter solutions. The CCG results are compared to the creep crack growth prediction models. Based on the creep properties, creep ductility and metallurgical observations of the fracture behaviour of the AR and PC materials, it has been shown that short term creep crack growth tests on PC material may be used to predict long term creep crack initiation (CCI) and CCG behaviour of AR material at 550 °C.