Hydraulics and heat transfer in the IFMIF liquid lithium target: CFD calculations

CFD (Computational fluid dynamics) calculation turns out to be a good approximation to the real behavior of the lithium (Li) flow of the target of the international fusion materials irradiation facility (IFMIF). A three-dimensional (3D) modelling of the IFMIF design Li target assembly, made with the CFD commercial code ANSYS-FLUENT has been carried out. The simulation by a structural mesh is focused on the thermal-hydraulic analysis inside the Li jet flow. For, this purpose, the two deuteron beams energy deposition profile is modelled as an energy source term inside the volume of liquid affected. Turbulence is estimated using the RNG k–ɛ model, and a surface-tracking technique applied to a fixed Eulerian mesh called volume of fluid (VOF) is used to determine the position of the free surface. Calculations varying the jet velocity from a range of 10–20 m/s, show that maximum calculated temperatures are still below the lithiumʹs boiling point, due to the increase of the pressure induced by centrifugal force.