Manufacturing, testing and post-test examination of ITER divertor vertical target W small scale mock-ups

ENEA is involved in the International Thermonuclear Experimental Reactor (ITER) R&D activities. During the last years ENEA has set up and widely tested a manufacturing process, named Hot Radial Pressing (HRP), suitable for the construction of high heat flux plasma-facing components, such as the divertor targets. frame of the EFDA contract six mock-ups were manufactured by HRP in the ENEA labs using W monoblocks supplied by the Efremov Institute in St. Petersburg, Russian Federation and IG CuCrZr tubes. ing to the technical specifications the mock-ups were examined by ultrasonic technique and after their acceptance they were delivered to the Efremov Institute TSEFEY-M e-beam facility for the thermal fatigue testing. The test consisted in 3000 cycles of 15 s heating and 15 s cooling at 10 MW/m2 and finally 1000 cycles at 20 MW/m2. the testing the ultrasonic non-destructive examination was repeated and the results compared with the investigation performed before the testing. ostructure modification of the W monoblock material due to the overheating of the surfaces and the copper interlayer structure modification were observed in the high heat flux area. akage points of the mock-ups that did not conclude the testing were localized in the middle of the monoblock while they were expected between two monoblocks. aper reports the manufacturing route, the thermal fatigue testing, the pre and post non destructive examination and finally the results of the destructive examination performed on the monoblock small scale mock-ups.