Surface composition and morphology changes of JET tiles under plasma interactions

Plasma interactions with the main chamber of magnetic fusion devices result in net erosion from some areas and net deposition at other locations. However, high energy particle irradiation means that there are continuous erosion and re-deposition processes involved, creating new surface structures. Although the net deposition can be readily assessed, net erosion and material mixing is difficult to determine. In 2005 marker tiles were mounted in the JET vessel which have a thin tungsten (W) layer deposited on the CFC substrate with a ∼10 μm carbon layer on top. This layered structure was designed to determine the areas where some erosion had occurred during JET plasma operations, when the tiles were removed for analysis in 2007. aper describes the results from a set of tiles mounted in a poloidal limiter (in Octant 8) at the outer wall of the main chamber; a comparison is made between the data from tiles near the top, middle and bottom of the limiter. A set of ion beam techniques together with electron microscopy were used to provide a detailed analysis of the tiles. In general, since plasma interaction is strongest near the centre of the limiter where the tile is closest to the boundary of the confined plasma, erosion dominated on the central tiles, with deposition further from the plasma boundary. Also the amount of retained deuterium is higher in the tiles located in the upper and lower regions of the plasma chamber.