Design, integration and feasibility studies of the Tore-Supra West divertor structure

Actively cooled tungsten plasma facing components will be used in the ITER divertor. In order to fully validate such a technology (industrial manufacturing, operation with long plasma duration), the implementation of a tungsten axis symmetric divertor in the tokamak Tore-Supra is studied. With this major upgrade, so called WEST (Tungsten Environment in Steady state), Tore-Supra will be the only European tokamak able to address the problematic of long plasma discharges with an actively cooled metallic divertor.To do so, it is planned to install two symmetric divertor coils inside the vacuum vessel. This assembly, called divertor structure, is made up of two stainless steel casings containing a copper winding pack cooled by hot pressurized water (200 °C, 4 MPa). These two casings are located at the top and bottom of the vacuum vessel in order to create two magnetic X-point areas, which are protected by W-PFCs (Tungsten Plasma Facing Components) in order to extract the thermal loads. The two casing are robustly maintained together by 18 brackets in order to constitute a rigid assembly attached thanks to 12 legs (one per lower vertical port) outside the Tore_Supra vacuum vessel.The paper will illustrate the technical developments performed during 2011 in order to produce a preliminary design of the Tore-Supra WEST divertor structure with a particular focus on: the mechanical design of this major component and its integration in the Tokamak, the manufacturing issues and the technical results of the feasibility studies done with industry as well as the design of a scale one coil mock up.