Material mixing on W/C twin limiter in TEXTOR-94

In order to investigate the effect of mutual contamination between tungsten (W) and carbon (C) and its influence on the plasma, a W–C twin test limiter, half made of W and the other half of C, was inserted into the edge plasma of TEXTOR-94 under ohmic and NBI heating conditions. The contamination process was observed by spectroscopy, and the intensity distribution of WI showed migration of W onto the C side by the successive cycles of sputtering and prompt redeposition. On the other hand, the deposition of C on the W surface was not obvious. Most of the hydrogen (deuterium) on the limiter was found to be retained in the deposited layers and that in the deposited C layer much higher than that in the deposited W layer. This indicates that tritium retention is smaller in metallic deposits above 500 K. The AES analysis conducted after the exposure of the test limiter showed that W deposited on C reacted with the substrate to form carbides at higher temperatures. The thickness of carbide layer, and/or the content of W in C were influenced by the temperature and flux distributions, and no carbide layer was formed at the limiter edge where the temperature was relatively low.