Title of article
Determination the Mechanical Stress on the Cutter Bar of the Harvesting Combine by Abaqus
Author/Authors
Shirneshan, Alireza Department of Mechanical Engineering - Faculty of Engineering - Najafabad Branch Islamic Azad University, Najafabad, Isfahan, Iran , Najafabadi, Ali Hori Department of Mechanical Engineering - Faculty of Engineering - Najafabad Branch Islamic Azad University, Najafabad, Isfahan, Iran , Hosseinzadeh Samani, Bahram Department of Mechanics of Biosystem - University, Shahrekord, Iran
Pages
10
From page
47
To page
56
Abstract
In this paper, to simulate mechanical stress on the cutter bar of the harvesting combine during
cutting of wheat stems, first, shearing strength of the stems was measured for various moisture
content levels and cutting heights. After that the cutter bar of combine was simulated by Abaqus
with the specified conditions. The results of the simulation showed that with increase in moisture
content of stem, shear stress on the blade is increased up to 18% due to the viscous damping
effect of the moisture of stem. On the other hand, with increase in cutting height, shear stress on
the blade is decreased up to 12% because of the accumulation of less mature fibers at the lower
levels of stems.
Keywords
Stress , Moisture content , Cutting heights , Shearing strength , Harvesting Combine
Journal title
Journal of Modern Processes in Manufacturing and Production
Serial Year
2015
Record number
2523668
Link To Document