Title of article
DESIGN AND FABRICATION OF CRANIOPLASTY PROSTHESES: FIT EVALUATION BETWEEN PHANTOMBASED HAPTIC ENVIRONMENT AND MATERIALISE 3-MATIC SOFTWARE
Author/Authors
Hasib, H. Universiti Teknikal Malaysia Melaka (UTeM) - Faculty of Manufacturing Engineering, Malaysia , Yahaya, S.H. Universiti Teknikal Malaysia Melaka (UTeM) - Faculty of Manufacturing Engineering, Malaysia , Kamely, M.A. Universiti Teknikal Malaysia Melaka (UTeM) - Faculty of Manufacturing Engineering, Malaysia , Bani Hashim, A.Y. Universiti Teknikal Malaysia Melaka (UTeM) - Faculty of Manufacturing Engineering, Malaysia , Najib, A.M.M. Universiti Teknikal Malaysia Melaka (UTeM) - Faculty of Manufacturing Engineering, Malaysia , Simha, S.S. North Carolina State University - Department of Industrial and Systems Engineering, USA
From page
87
To page
96
Abstract
Two different design methods for customized cranioplasty prostheses are presented in this paper. The first approach is designing the digital model of the cranial implants in a haptic environment, utilizing a combination of a PHANToM haptic device and a freeform software called Claytools. The other method makes use of a software solution provided by Materialise Inc. known as 3-matic. Next, the skull models and the designed implants are fabricated via stereolitography (SLA). Finally, the implants’ fit over the skull models are evaluated to determine the most accurate method
Keywords
SCranioplasty Prostheses , Haptic Environment , 3 , Matic Software , Stereolitography
Journal title
Journal of Advanced Manufacturing Technology
Journal title
Journal of Advanced Manufacturing Technology
Record number
2593653
Link To Document