Title of article
Design and Implementation of Flyback Converter for Electrical Discharge Machining Power Generator
Author/Authors
Mahmud, Nazriah Universiti Teknologi Malaysia - Faculty of Biosciences and Medical Engineering, Malaysia , Yahya, Azli Universiti Teknologi Malaysia - Faculty of Biosciences and Medical Engineering, Malaysia , Andromeda, Trias Universiti Teknologi Malaysia - Faculty of Electrical Engineering, Malaysia , Hashim, Nor Liyana Safura Universiti Teknologi Malaysia - Faculty of Biosciences and Medical Engineering, Malaysia
From page
65
To page
70
Abstract
Electrical Discharge Machining process has been widely used for manufacturing micro components due to its contactless process. Its application has also been introduced in machining micro pits on hip implant. In this paper, a new design of power generator is proposed in order to reduce micro crack while machining take place. Flyback Switch Mode Power Supply has been chosen because of its high efficiency. The simulation of Flyback converter using LT Spice is presented. The result shows that the system achieves 95.9% of efficiency. Experimental results show that flyback converter able to produce DC voltage up to 111.6 V.
Keywords
Flyback , electrical discharge machining
Journal title
Jurnal Teknologi :F
Journal title
Jurnal Teknologi :F
Record number
2716390
Link To Document