Author/Authors :
Justus Reymond, D Department of Civil Engineering - SRM Institute of Science and Technology, Kattankulathur, Chengalpattu, Tamil Nadu, India , Sudalaimuthu, K Department of Civil Engineering - SRM Institute of Science and Technology, Kattankulathur, Chengalpattu, Tamil Nadu, India
Abstract :
BACKGROUND and OBJECTIVES: Heavy metals can enter the food chain in the aquatic
environment and become available for accumulation in biota. Industrialization and
agricultural developments are progressively causing ecological concerns, which must be
addressed. This study aimed to ascertain the heavy metals in Tamiraparani River sediments
using contamination factor and contamination degree, which would help administrative
bodies implement control measures. For heavy metal analysis, this study is unique in that it
focuses on the far downstream, where the sediment deposition is higher.
METHODS: Using an atomic absorption spectrophotometer, the abundance of iron,
manganese, copper, and chromium was determined in this study. In this study, the heavy
metals in the sediments are selected on the basis of previous studies. Additionally, to assess
sediment pollution status, contamination factor, contamination degree, and pollution load
index were used. Furthermore, a geographical information system was used to analyse
the temporal variations of heavy metals in the sediments for different spatial locations
downstream of the river.
FINDINGS: The study revealed that iron > manganese > chromium > copper concentration
ranges from 3838 to 853, 68 to 7.8, 8.3 to 0.5, and 5.6 to 0.26 milligram per kilogram,
respectively. The contamination factor ranges from 0.006 to 0.093 among all the sampling
locations, heavy metals, and seasons, indicating that the pollution is in a low-level category.
The contamination degree ranges from 0.039 to 0.378 among sampling stations and seasons,
also indicating low-category pollution. The pollution load index value ranges from 0.004 to
0.092, which is less than 1 (guideline value), indicating less pollution impact. The seasonal
variation shows that the post-monsoon is highly polluted because of the excessive sediment
deposit from upstream after monsoon rainfall.
CONCLUSION: The contamination factor and contamination degree are within the acceptable
limit. However, they are in an increasing phase during monsoon seasons, which indicates that
heavy metals are from industries and are built up along the river banks upstream. Additionally,
chromium and copper are in high concentrations during post-monsoon (chromium = 6.643,
copper = 5.636) than during pre-monsoon because of anthropogenic activities and industrial
waste discharge into the river stream.
Keywords :
Contamination factor , Contamination degree , Geographical information system , Heavy metals , Pollution load index