Batch production of polyhydroxyalkanoate by low-polyphosphate-content activated sludge at varying pH

Polyhydroxyalkanoate (PHA), a biodegradable plastic, can be produced from excess activated sludge by utilizing intracellular glycogen and polyphosphate as energy sources under growth-limiting conditions. Activated sludge of 2%, 6%, and 8% polyphosphate with similar glycogen content of 33% was investigated for batch PHA production by varying the pH values from 6 to 8. Acetate applied at 1000 mg COD/L was almost exhausted within 80 min of anaerobic stage. The remaining glycogen in the sludge was higher at a lower pH because of less energy used for acetate uptake. Highest PHA content of 51% was obtained from sludge with an 8% polyphosphate content at pH 8. PHA production occurred rapidly within the first 20 min, with a productivity rate of 2.19 g PHA/L-h. The results in this study indicate that PHA production by using activated sludge is a promising alternative to a typical pure culture approach.