Air/Water Oxygen Transfer in a Biological Aerated Filter

The oxygen-transfer characteristics of an upflow biological aerated filter filled with angular clay media were determined over a wide range of gas and liquid flow rates. Liquid-side, oxygen-transfer coefficients (KLa) were measured using a nitrogen gas stripping method under abiotic conditions and were found to increase as both gas and liquid superficial velocity increases, with values ranging from 12 to 110 h^–1 based on empty bed volume. The effect of gas and liquid velocity, wastewater to clean water ratio, and temperature dependence was correlated to within ±20% of the experimental KLa value. Stagnant gas holdup is roughly double in wastewater compared to clean water, but the dynamic gas holdup is the same. The oxygen-transfer coefficient is directly proportional to the dynamic gas holdup. Stagnant gas holdup does not influence the rate of oxygen transfer. The results suggest that dynamic gas holdup largely determines the specific interfacial area (a), whereas the interstitial liquid velocity largely controls the oxygen-transfer coefficient A(KL).