Thermal Conductivity of the Refrigerant Mixtures R404A, R407C, R410A, and R507A

New thermal conductivity data of the refrigerant mixtures R404A, R407C, R410A, and R507C are preseInted. For all these refrigerants, the thermal conduc- tivity was measured in the vapor phase at atmospheric pressure over a tem- perature range from 250 to 400 K and also at moderate pressures. A modified steady-state hot-wire method was used for these measurements. The cumulative correction for end effects, eccentricity of the wire, and radiation heat transfer did not exceed 20. Calculated uncertainties in experimental thermal conductivity are, in general, less than \1.50. All available literature thermal conductivity data for R404A, R407C, R410A, and R507C were evaluated to identify the most accurate data on which to base the thermal conductivity model. The thermal conductivity is modeled with the residual concept. In this representation, the thermal conductivity was composed of two contributions: a dilute gas term which is a function only of temperature and a residual term which is a function only of density. The models cover a wide range of conditions except for the region of the thermal conductivity critical enhancement. The resulting correlations are applicable for the thermal conductivity of dilute gas, superheated vapor, and saturated liquid and vapor far away from the critical point. Comparisons are made for all available literature data.