A Model for the Mechanical Behaviour of Bentheim Sandstone in the Brittle Regime

The mechanical behaviour of Bentheim sandstone, a homogeneous quartz-rich sandstone with porosity of 22.8%, was investigated by triaxial compression tests conducted on dry samples. At confining pressures up to 35 MPa, the failure mode was characterized by a typical brittle deformation regime, as the samples showed dilatancy and failed by strain softening and brittle faulting. Previous studies have shown that the mechanical behaviour and failure mode of brittle porous granular rocks are governed by the time-dependent growth of microcracks. We analyse this process using the ‘‘Pore Crack Model’’ based on fracture mechanics analysis. It is consistent with the microstructure of porous granular rocks since it considers the growth of axial cracks from cylindrical holes in two dimensions. These cracks grow when their stress intensity factors reach the subcritical crack growth limit. Interaction between neighbouring cracks is introduced by calculating the stress intensity factor as the sum of two terms: a component for an isolated crack and an interaction term computed using the method of successive approximations. It depends on crack length, pore radius, pore density, and applied stresses. The simulation of crack growth from cylindrical holes, associated with a failure criterion based on the coalescence of interacting cracks, is used to compare the theoretical stress at the onset of dilatancy and at macroscopic rupture to the experimental determined values. Our approach gives theoretical results in good agreement with experimental data when microstructural parameters consistent with observations are introduced.