Effects of MEA preparation on the performance of a direct methanol fuel cell

The effects of membrane electrode assemblies (MEAs) fabrication methods (spraying and scraping methods) and the hot-pressing pretreatment of anode electrodes on the performance of direct methanol fuel cells (DMFCs) were investigated. The MEA prepared with scraped anode catalyst layer without the hot-pressing pretreatment showed the highest power density of 67 mW cm−2 at 80 °C and ambient pressure. The scraping method proved to be a little more profitable for improving the cell performance than the spraying method. Atomic force microscopy (AFM) analysis revealed relatively smooth surface of the scraped anode catalyst layer compared with that of sprayed anode catalyst layer. Scanning electron microscopy (SEM) images showed that a suitable number of cracks which were uniformly distributed on the surface of scraped catalyst layer formed a porous structure. It was demonstrated that the surface structure and roughness of the anode catalyst layer had less effect on the performance of the anode electrode in a DMFC. The hot-pressing pretreatment of the anode electrode decreased the performance of the MEA due to the difficulty for electrons and mass transport in the anode electrode, namely the increase of internal cell resistance.