High temperature electrolyte supported Ni-GDC/YSZ/LSM SOFC operation on two-stage Viking gasifier product gas

This paper presents the results from a 150 h test of a commercial high temperature single planar solid oxide fuel cell (SOFC) operating on wood gas from the Viking two-stage fixed-bed downdraft gasifier, which produces an almost tar-free gas, that was further cleaned for particulates, sulphur and tar traces. The chosen SOFC was electrolyte supported with a nickel/gadolinium-doped cerium oxide (Ni-GDC) anode, known for its carbon deposition resistance. Through humidification the steam to carbon ratio (S/C) was adjusted to 0.5, which results in a thermodynamically carbon free condition at the SOFC operating temperature T = 850 °C. The cell operated with a fuel utilisation factor (Uf) around 30% and a current density of 260 mA cm−2 resulting in an average power density of 207 mW cm−2. Throughout the duration of the test, only a minor cell overpotential increase of 10 mV was observed. Nevertheless, the V–j (voltage–current density) curves on H2/N2 before and after the wood gas test proved identical. Extensive SEM/EDS examination of the cellʹs anode showed that there was neither carbon deposition nor significant shifts in the anode microstructure or contamination when compared to an identical cell tested on H2/N2 only.