Improvement of a solid phase extraction method for analysis of lipid fractions in muscle foods

The most used method for muscle lipid fractionation into major lipid classes was modified for improving its separation efficiency. Extracted lipids from a masseter muscle of one Iberian pig were separated into neutral lipids (NL), free fatty acids (FFA) and polar lipids (PL) using aminopropyl minicolumns, following the extensively used method of Kaluzny et al. [1] (old method-OM-) and a method based on that, developed by Pinkart et al. [2] with some (modifications modified method–MM). Obtained lipid classes were further analysed by TLC and lipid fractions were identified. TLC evidenced the presence of a certain amount of PL in the NL fraction obtained with the OM. On the other hand, using the MM only an almost undetectable presence of PL was evidenced in the NL fraction. Fatty acid composition of NL, PL and FFA obtained with each method was studied by gas chromatography. Fatty acid profile of NL was strongly influenced by the separation method used. Thus, NL obtained using the OM showed higher amounts of saturated fatty acids (SFA) and polyunsaturated fatty acids (PUFA) and lower of monounsaturated fatty acids (MUFA) than those obtained using the MM. Moreover, NL obtained using the OM showed the presence of fatty alcohols, constituents of phospholipids (PhL) absent or present only in trace amounts in acylglycerols. This profile reflects the coelution of PL in the NL fraction. Fatty acid profile of FFA and PL fractions was also influenced by the solid phase extraction (SPE) method used, but to a lesser extent.