Simulating the Behavior of GRS Bridge Abutments

Geosynthetic-reinforced soil (GRS) bridge-supporting abutments are similar in principle to GRS retaining walls, except that GRS abutments are typically subjected to a much higher area load, and that the loads are close to the wall face. The GRS abutment technology is relatively new, but it has great potential, and it has been gaining some popularity in recent years. This paper describes the finite element analyses of two full-scale loading tests of GRS bridge abutments referred to as the “National Cooperative Highway Research Program (NCHRP) experiment.” The analysis was carried out using the computer program Dyna3d, developed at the Lawrence Livermore National Laboratory. The finite element analysis of the NCHRP experiment will help with the understanding of the complex behavior of GRS structures in general, and the behavior of GRS bridge abutments with modular block facing in particular. The analysis of the two full-scale loading tests allows the loading conditions that are of greatest concern in the design of the bridge abutments to be examined rationally. The analysis shows that the performance of a GRS abutment, resulting from the complex interaction among the various components, while subject to a service load or a limiting failure load can be simulated in a reasonably accurate manner. In addition, a parametric study was conducted to investigate the performance of the modular block facing GRS bridge abutments subjected to live and dead loads from a bridge superstructure. This study investigated the performance of the GRS bridge abutments as they are affected by backfill properties, reinforcement stiffness properties, and reinforcement vertical spacing.