Scaling effects on modeled surface energy-balance components using the NOAH-OSU land surface model

As surface exchange processes are highly non-linear and heterogeneous in space and time, it is important to know the appropriate scale for the reasonable prediction of these exchange processes. For example, the explicit representation of surface variability has been vital in predicting mesoscale weather events such as late-afternoon thunderstorms initiated by latent heat exchanges in mid-latitude regions of the continental United States. This study was undertaken to examine the effects of different spatial scales of input data on modeled fluxes, so as to better understand the resolution needed for accurate modeling. A statistical procedure was followed to select two cells from the Southern Great Plains 1997 hydrology experiment region, each 20 km×20 km, representing the most homogeneous and the most heterogeneous surface conditions (based on soil and vegetation) within the study region. The NOAH-OSU (Oregon State University) Land Surface Model (LSM) was employed to estimate surface energy fluxes. Three scales of study (200 m, 2 and 20 km) were considered in order to investigate the impacts of the aggregation of input data, especially soil and vegetation inputs, on the model output. Model results of net radiation and latent, sensible and ground heat fluxes were compared for the three scales. For the heterogeneous area, the model output at the 20-km resolution showed some differences when compared with the 200-m and 2-km resolutions. This was more pronounced in latent heat (12% decrease), sensible heat (22% increase), and ground heat flux (44% increase) estimation than in net radiation. The scaling effects were much less for the relatively homogeneous land area with 5% increase in sensible heat and 4% decrease in ground heat flux estimation. All of the model outputs for the 2- and 20km resolutions were in close agreement. The results suggested that, for this study region, soils and vegetation input resolution of about 2 km should be chosen for realistic modeling of surface exchange processes. This resolution was sufficient to capture the effects of sub-grid scale heterogeneity, while avoiding the data and computational difficulties associated with higher spatial resolutions.