Predicting diffuse-source transfers of surfactants to surface waters using SWAT Original Research Article

Chemicals present in domestic wastewater can adsorb to solid phase materials during sewage treatment. If biosolids (or sewage sludge) are applied to land, these chemicals can be transferred to soil. Under some circumstances they can also be transferred to surface waters during storm events either in solution or attached to sediment. In this paper we describe the utility of the SWAT 2000 model to estimate diffuse-source surface water exposure to “down-the-drain” chemicals. The model was applied hypothetically to predict the behaviour of linear alkylbenzene sulphonate (LAS), an anionic surfactant commonly used in household detergents, in a small catchment in Bedfordshire, UK, where it has previously been successfully validated for stream flow, sediments and pesticides. LAS transfers were estimated for two scenarios: (1) realistic and (2) reasonable worst case, based on assumptions on sludge application rates and the concentration of LAS in sludge. In addition, the sensitivity of the model output to the proportion of the catchment to which sludge is applied was established. Soil wetness and the total quantity of biosolids applied were the biggest determinants of chemical transport from the catchment. The potential of SWAT as a higher-tier tool in environmental risk assessments is discussed.