Elaboration and application of mathematical model for estimation of mould contamination of some building materials based on ergosterol content determination

The study presents a mathematical function describing a correlation between the amount of ergosterol and the number of colony-forming units (CFU) of mould contaminating selected building materials such as: a block of cellular concrete, gypsum—carton board and gypsum—carton board covered with emulsion paint. The dependence obtained for a particular material as well as an average dependence for all the investigated materials has been described by means of an exponential equation. It has been found out that there is high, statistically significant correlation between ergosterol content and CFU number of mould in all of the building materials. The correlation coefficients have ranged from r=0.790 to 0.933. The elaborated equation describing the above dependence can be applied to estimate mould contamination by means of culture methods within the range 103–108 CFU/m2 of the surface. In addition, the estimated level of ergosterol in these materials has been shown to be the criterion by which to evaluate the degree of filamentous fungal contamination. It has been assessed that an ergosterol content exceeding the level of 3.96 mg/m2 indicates the active development of mould. This criterion has been applied to evaluate several building materials i.e.: concrete, gypsum board, emulsion coatings, brick, plaster, wallpaper, glass wool, mineral wool and wood. No statistically significant differences have been observed between CFU number of mould calculated from a model equation on the basis of the ergosterol content and CFU number of mould experimentally determined by traditional methods. The results presented in this paper show that the elaborated equation of correlation between the ergosterol content and CFU number of mould can be applied to estimate mould contamination of different building materials, based on the determination of ergosterol.