Plastic loads of pipe bends under combined pressure and out-of-plane bending

This paper provides plastic limit and TES (twice-elastic-slope) plastic load solutions for 90◦ pipe bends under combined pressure and out-of-plane bending, via threedimensional non-linear FE analyses using elastic-perfectly plastic materials. Without internal pressure, a closed-form approximation is given. For combined pressure and out-of-plane bending, tabulated data are given, from which TES plastic loads can be interpolated. It is found that TES plastic loads for pipe bends under out-of-plane bending are lower than those under in-plane opening bending, but are higher than those under in-plane closing bending. It suggests that the in-plane closing bending mode is the most critical loading mode for 90◦ pipe bends, which is fully consistent to existing findings