Tensile and flexural properties of injection-moulded short glass fibre and glass bead ABS composites in the presence of weldlines

The effect of weldline on tensile and flexural properties of ABS reinforced with short glass fibres (ABS/ GF) and spherical glass beads (ABS/GB) was investigated as a function of glass fibre and glass bead concentrations. The weldline was formed in the moulded specimens by direct impingement of two opposing melt fronts (i.e. cold weld). It was found that elastic modulus of ABS/GF composites, with or without weldlines increased linearly with increasing volume fraction of fibres (/f), according to the rule-of-mixtures for moduli. The presence of weldline reduced tensile and flexural modulus of the ABS/GF composites. Weldline integrity factor for elastic modulus of ABS/GF composites decreased linearly with increasing /f. Results showed that tensile and flexural strength of ABS/ GF increased with increasing /f in a nonlinear fashion. Flexural strength was consistently greater than tensile strength for the same /f. Weldline affected both strengths in a significant way; weldline integrity factor decreased with increasing /f and was independent of loading mode. Tensile and flexural modulus of ABS/GB composites increased linearly with increasing volume fraction of glass beads (/b), showing no loading mode dependency. Although modulus of the ABS/GB system was not affected significantly by the weldline, its strength was affected, and more so in flexure than in tension. Weld and unweld strengths decreased with increasing /b in both tension and flexure according to Piggott and Leidner relationship; for the same /b, flexural strength was always greater than tensile strength. Weldline integrity factor for tensile strength of ABS/GF system was considerably lower than that for ABS/GB system but weldline integrity factor for flexural strength was almost the same for the two composite systems.