Effect of dynamic strain aging on the leak-before-break analysis in SA106 Gr.C piping steel Original Research Article

The characteristics of dynamic strain aging (DSA) on material properties used in leak-before-break (LBB) analysis were discussed. Using these material data, the effect of DSA on the LBB analysis was estimated through the evaluation of leakage-size crack and flaw stability in SA106 Gr.C piping steel. Also, the results were represented as a form of `LBB allowable load windowʹ. In the DSA temperature region, the leakage-size crack length was smaller than that at other temperatures and it increased with increasing tensile strain rate. In the results of flaw stability analysis, the lowest instability load appeared at the temperature corresponding to the minimum J–R curve which was caused by DSA. The instability load depended on the loading rate of J–R data, and decreased with increasing tensile strain rate at the plant operating temperature. These are due to the strain hardening characteristic and strain rate sensitivity of DSA. In the `LBB allowable load windowʹ, the LBB allowable region at the temperature and loading conditions where DSA occurs was decreased by about 30% compared with that in other conditions.