CFD study on coolant mixing in VVER-440 fuel rod bundles and fuel assembly heads Original Research Article

A CFD model of VVER-440 fuel assembly heads was developed based on the technical documentation of a full-scale test facility built in the Kurchatov Institute, Russia. Steady-state and transient calculations were performed to validate the model with a measurement set. Effects of the spatial resolution, turbulence models, difference schemes and different inlet boundary conditions were investigated. Inlet boundary conditions were determined with both the COBRA subchannel code and a fuel rod bundle CFD model that was built for this special purpose. The results were compared against experimental data. The sensitivity studies showed that a grid of about 8 million cells, high resolution scheme and BSL Reynolds stress model are suitable sets to provide accurate prediction for the signal of the in-core thermocouple. The best prediction was achieved with transient calculation using inlet boundary conditions generated with the CFD fuel rod bundle model. The results indicated that the coolant mixing is intensive but not perfect in the assembly head. Besides, the significant role of the outflow from the central tube was also proven. The transient runs revealed relatively large temperature fluctuations near the in-core thermocouple housing.