The contribution of non-wetting droplets to direct cooling of the fuel during PWR post-LOCA reflood Original Research Article

During the reflood of a Pressurised Water Reactor (PWR) following a loss of coolant accident, precursory cooling prior to the arrival of the rewetting front is of vital importance in limiting the rise in cladding temperature before rewet. This precursory cooling is achieved by a flow of superheated vapour, with entrained saturated drops, which evaporate into the vapour and act as a heat sink. In this paper we investigate a complementary mechanism; the direct cooling of the cladding by the drops themselves. Cladding temperatures are such that wetting by these droplets does not occur. On the contrary, droplets bounce off a vapour cushion formed during the ∼10 ms or so that they are in close proximity to the cladding. Using a combination of previous experimental correlations and recent CFD calculations, we estimate the rate of heat removal from the cladding surface as a result of the droplet impingement. Thus, we estimate the heat removed as a result of one impingement and estimate the total rate of heat removal by estimating the number droplets impinging on the cladding per unit surface area. The heat extracted by those droplets is found to be about 1/10 of the heat extracted by single-phase vapour under typical reflood conditions. Though there significant uncertainties in these estimates, it does seem that direct cooling by droplets, not generally incorporated in analyses of reflood, could actually be making a significant contribution to keeping cladding temperatures down to acceptable levels.