Distribution parameter and drift velocity for two-phase flow in a large diameter pipe Original Research Article

In view of practical importance of the drift flux model for two-phase flow analysis in general, and in the analysis of nuclear reactor transients and accidents in particular, the distribution parameter, and the drift velocity have been studied for two-phase flow in a vertical large diameter pipe. In this, study, local measurements were performed on flow parameters, such as void fraction, gas velocity and, liquid velocity in a vertical upward air–water two-phase flow in a pipe of 200 mm inner diameter and, 25 m in height by using the local sensor techniques such as hot-film probes, optical multi-sensor, probes and differential pressure gauges. Two-phase flow regimes in a vertical large diameter pipe, were classified into bubbly, churn and slug flows according to the visual observation. The values of the, distribution parameter and the mean drift velocity were determined directly by their definition using experiment data of the local flow parameters in a two-phase flow in a large diameter pipe. Various existing drift flux correlations were compared with the present experimental results and experimental data obtained by other researchers. A detailed discussion on the problems of these correlations was presented in this paper.