Thermal performance of an air solar collector with an absorber plate made of recyclable aluminum cans

The present paper describes the development and testing of an efficient single-glass air solar collector with an absorber plate made of recyclable aluminum cans (RAC). This collector was designed as a proposal to use recycle recyclable materials to build absorber plates of air solar collectors at an acceptable cost. The absorber plate of the collector consisted of eight circular cross section air flow channels of 128 recyclable aluminium cans. Each channel was built with 16 recyclable cans blackened with common opaque black paint of 0.903 absorptance and 0.097 reflectance. The design parameters to determine the size of the collector were obtained by implementing a simulation model for double flow air solar collectors. Also, to determine the appropriate configuration for a uniform air flow distribution inside the eight RAC air channels, a hydrodynamic numerical study was carried out. The RAC air solar collector designed and built was tested outdoors following the ASHRAE 93-86 standard to determine the time constant, the thermal efficiency and the incidence angle modifier. Comparison between the predicted theoretical temperatures and the measured ones were in good agreement. Comparison between the thermal efficiency of the RAC air solar collector with the ones reported in the literature is presented. 2004 Elsevier Ltd. All rights reserved.